[. . . ] [. . . ] Tools Needed: Torque wrench with 4mm hex key. 1 2 Step 1: With the saddle resting top side down, position the cradle plate as shown on the rails. 3 Step 2: Position the two lower clamps as shown. The clamps rest on the cradle plate and rails. 4 Step 3: Press the top of the seatpost down into position while sliding the 2 lower clamp pieces into place. 5 Step 4: While holding the lower clamp pieces in place, install the 4mm hex bolt (lightly greased). Step 5: Install the seatpost in the bike and then micro adjust accordingly. NOTE: Always remember to keep bolt, threads and surface contact points clean. [. . . ] [. . . ]